DANBO PAPERCRAFT PDF
I have finally finished my papercraft danbo, or shall I say danbo pepakura. This model is about 12cm high and only uses 2 sheets of paper. A website blog about papercraft and scale paper model. 18 February 55 Rauf Raphanus Simple Paper Craft Danbo Papercraft. This paper model is a Fedex Danbo, created by KIKILO, and shared by Pedro Perez. You may get this papercraft toy here: Fedex Danbo Free.
|Published (Last):||28 May 2004|
|PDF File Size:||16.82 Mb|
|ePub File Size:||9.53 Mb|
|Price:||Free* [*Free Regsitration Required]|
First – we prepare all the equipment that we will use. Cut and paste the pictures 16 piece color white glue.
It is part of the arm. Cut and glue in Figure 3 upper arm created in step 1.
Give the glue on both the teeth and glue pieces of figure 7 on each side so as cylinders. Connect the parts are made from step 3 and step 2, thus forming a movable arm see picture. Cut holes in figure 8 and 3 parts white.
In figure 10 there are lines cross in a circle, cut it with a razor kurter line, then plug it into the big hole in the figure 8. Papercrwft fold up the whites. If this confused picture no explanation explanation.
After that cut the figure 11 and closed four white lines earlier. Try to be spinning neck joint profit.
Then cut the images 18 and And do it like that. Then glue the body.
Attach the arm to the left and right parts that you created in step 5 earlier. Make 2 cylinders again as step 3, but with images 14, Cut 13 and connect it to the 2 cylinder before see picture.
Cut the appropriate figure 12 fold lines and glue the cylinder that was created in step 7. Glue the result from step 8 to the upper body created in step 5 the neck.
My Danbo Papercraft
Cut Figure 1, paperccraft corresponding folding pattern. Cut also figure 4 and figure 1 the eye holes, and attach pieces of figure 4 in Figure 1 so that her eyes look more real optional. Connect the head from step 10 to the neck made in step 9. Figure 2 Cut and glue, let the better of the foot.
Danbo Papercraft Model
Cut out pictures of 17 and 5, then create a cylinder as step 3, then pairs of legs from step 12 and try to get round. Glue both sides of the cylinder to the bottom of the body. Newer Post Older Post Home.